It is important to use extra care when using a rough terrain scissor lift. Operators should be fully aware of the surrounding environment. Extended booms on the equipment act as levers from the drive units center. For instance, a 6 inch bump can lead to a 3 foot bounce when the driver is at the driver controls. Take into consideration all other traffic nearby, because they may not be aware that you are moving. Plan your assent cautiously. Park the boom lift on a flat surface which has no water or mud. These areas conceal deep potholes that could be probably cause the occupants to fall if the tires fell into the holes. If provided, use all of the outriggers, extended to their full extension position. Be certain to only use wooden chalk blocks that are approved.
Some lifts will operate from the end of the boom on a metal platform. Long booms act levers on the drive unit. While you are at the driver controls, a 6-inch bump can lead to a 3-foot bounce. Be aware of all other traffic. They may not be aware that you are moving. Plan your assent. Park the boom lift on a flat surface free of any water or mud. These areas could conceal deep potholes wherein the lift tires can fall, tipping the occupants. Extend all outriggers, if provided, fully. Place only approved wooden chalk blocks beneath the outrigger pads to prevent the unit from moving.
Overhead power lines are a serious hazard for lift operators regardless of what lift is being utilized. Like for instance, if the operator of the platform is not being aware, or if the platform is being controlled by employees on the ground that is not able to accurately access proximity to wiring and therefore, either the platform itself or the worker could be easily brought into contact with electrical wires. The worker can be electrocuted unfortunately unless properly insulated.