Inspect a Forklift
There are more than 10,000 workplace injuries related to forklifts happen every year, according to HRSDC and OSHA reports. Many of these mishaps are caused by driver error. Lack of appropriate equipment maintenance and check results in numerous others. Forklift operation and maintenance is not just the reason for personal injuries, but also of property damage. Forklifts can damage sprinklers, building structures and overhead pipes, and other equipment when used improperly. The following day by day inspections should be carried out in order to lessen the possibility of forklift accidents.
Prior to inspecting different fluid levels turn off the engine. Check these fluids: hydraulic oil, fuel, engine oil, brake fluid and coolant. The tires also have to be inspected for signs of wear and tear. Check the air pressure in the tires. Check the condition of the forks. The load backrest should be attached tightly. Do a visual check of the top-clip retaining heel and pin. After that carry out an inspection of the mast chains, hydraulic hoses, cables and stops. Make sure that the finger and overhead guards are attached firmly.
LP forklifts have propane tanks that need to be inspected for signs of damage, rust or corrosion. Test the battery's charge and electrolyte levels. All belts should be checked for wear. Check to make sure the owner's handbook is stored on-board the forklift in a storage compartment. Check the seat belt to make certain the latches are secure. Check the hood latch to make sure that it is functioning as it should.
Start the forklift and listen to the engine noise to make certain there are no unusual sounds. If there are, investigate promptly. Check the accelerator and the steering controls. The service brake and the parking break must be correctly working.
The drive control and tilt control must be checked to ensure proper functioning in both forward and reverse. Test the functioning of the lowering control and hoist, and the attachment control. Test the horn and lights. Afterward check the wipers, heater and defroster to make certain they are functioning smoothly. Inspect each and every gauge to ascertain that it is reading within functional limits.